Dominion Atlantic Railway Digital Preservation Initiative - Wiki

Use of this site is subject to our Terms & Conditions.

Difference between revisions of "Kentville Railyard"

From DARwiki
Line 30: Line 30:
 
File:Slide 78 - 6 may 76.JPG | Looking out from the [[Kentville Roundhouse|Kentville Turntable]] into the [[Kentville Railyard]] - 6th May 1976
 
File:Slide 78 - 6 may 76.JPG | Looking out from the [[Kentville Roundhouse|Kentville Turntable]] into the [[Kentville Railyard]] - 6th May 1976
 
File:Slide 51 - 31 may 76.JPG|[[Kentville Railyard]], May 31, 1976.
 
File:Slide 51 - 31 may 76.JPG|[[Kentville Railyard]], May 31, 1976.
 +
File:Tupper8.jpg|[[Kentville Railyard]] composite photo with the [[Kentville Coaling Tower]], [[Kentville Car Shop]] and the [[Kentville Repair Shop]], October 1990.
  
 
</Gallery>
 
</Gallery>

Revision as of 21:08, 29 July 2017

Kentville Railyard

D.A.R. railyard in Kentville.
D.A.R. railyard in Kentville.
D.A.R. railyard in Kentville.
D.A.R. railyard in Kentville on June 21, 1987.
Kentville including D.A.R. railyard.
D.A.R. railyard in Kentville, 1974. This drawing is difficult to read but is proportionately correct and was scanned at 200 DPI. The images below although not proportionally correct because they appeared photographed, not scanned, are the same map in sections and very readable with additional notes to explain some of the original notations on the map. The two buildings immediatley east of the roundhouse are the machine shop and blacksmith shop.

Railyard in sections

The above drawing is difficult to read but is proportionately correct and was scanned at 200 DPI. These images although not proportionally correct because they appeared photographed, not scanned, are the same map as above in sections and very readable with additional notes to explain some of the original notations on the map.

These images are just begging to be put on CAD. If anyone can help this way or advise what the proper way to set up a CAD file for land mapping is so others can do the tracing, please let us know. See this message thread on our forum: http://dardpi.ca/Forum/viewtopic.php?f=3&t=18#p49


External Links